Lumenier 30 amp ESC w/ SimonK AutoShot Firmware

The Lumenier 30 amp ESC with customized SimonK firmware including OneShot auto-detect is the perfect ESC to use on larger FPV quads such as the QAV400. This ESC is 51x25x10mm in size and big on power, supporting 30A on 4s. The ESC comes pre-loaded with the newest firmware, which is compatible with new features like "OneShot" (it will auto-detect if OneShot is enabled), Comp PWM (similar to KISS braking feature), compatible with all Lumenier motors up to 4 cell.

 

The Lumenier 30 amp AutoShot ESCs have been tested and are compatible with all Lumenier motors (FX1806, FX2206, FXC2206, RX2204, RX2206, FX2208), 2S-4S, both 5" and 6" props without sync loss issues or cogging. 

 

 

The Simonk AutoShot firmware is pre-calibrated with endpoints 1060us - 1860us. This corresponds to the default endpoints in both Baseflight and Cleanflight(The ESC is configured for cleanflight/baseflight by default). Therefore, "Calibration" procedure is not necessary or recommended. "Calibrate" at your own risk. Removal of the red wire in the signal cable is ok if you don't need 5v power out, but both the ground (black) and signal wire (white) need to be connected to the flight controller. Do not connect only the signal wire alone. 

Features

Active Braking / Damped Light / Comp_PWM

AutoShot (OneShot125 / FastPWM Auto Detect)

Customized to drive all motors without sync issues or cogging.

To enable new features on Baseflight:

- On Configuration tab, check "Enable OneShot" and "Enable FastPWM"

- Scroll down and click "Save" 

 

To enable new features on Cleanflight:

-On Configuration tab, check the "Enabled" box next to "ONESHOT125" Feature

-Scroll down and click "Save" 

 

Specifications

Max continuous load: ~30 amps

Burst Current: 40A/10sec

BEC: 5v/1amp max

Lipo Cells: 2 to 4 cells

Bare Cables

Weight: 26g (board) 32g (total with wires and connectors)

High quality N-FET only flashed with SimonK firmware and 5v 1A BEC 

Dimensions

51mm L x 25mm W x 10mm H

185mm signal wire / 5v power

85mm bare motor wires

70mm ESC power wires

More info: An ESC has either P-channel and N-channel FETs mixed or N-channel FETs only. The ESCs which use only N-channel FETs have the advantage of lower resistance, less losses and hence more efficiency. Learn more about N-channel and P-channel directly from Simon Kirby here.